MyNameRing.com - ring sizer

Print this page (sizer MUST measure 3 1/4" long to be accurate.)

(If the sizer doesn't print to the correct size, make a pencil mark and measure - use chart below to figure your size.)

Cutout the ring sizer (above) as close to edge as possible w/o cutting lines.

Place a small piece of clear tape on the end as pictured below:

Stick end w/ tape to bottom side of finger or toe & wrap around finger or toe.

Read your size at the line the arrow points to.

NOTES ON SIZING:

FINGER:

Be sure sizer is around the part of finger where you want to ring to fit. Pull snugly (not overly tight) and read ring size.

TOE:

Rings are often worn on the 2nd toe (next to the BIG toe) and is usually the same size as your pinky finger, but you can wear a ring on which ever toe you like. Measure end of toe first, then measure part of toe where you want ring to fit. Correct size will be between the two sizes, tending toward the smaller of the two sizes. The ring should fit quite snugly over the end of the toe. Using a lubricant such as Windex or soapy water is very helpful when putting your ring on.

Size	Length
0 =	1 7/16"L
.5 =	1 15/32"H
1 =	1 17/32"L
1.5 =	1 9/16"H
2 =	1 5/8" L
2.5 =	1 21/32" H
3 =	1 23/32" H
3.5 =	1 25/32" L
4 =	1 26/32" H
4.5 =	1 28/32" H
5 =	1 30/32" L
5.5 =	1 31/32" H
6 =	2 1/32"
6.5 =	2 3/32" L
7 =	2 4/32" H
7.5 =	2 6/32" L
8 =	2 8/32" L
8.5 =	2 10/32" L
9 =	2 11/32"
9.5 =	2 12/32" H
10 =	2 14/32"
10.5 =	2 15/32" H
11 =	2 17/32"
11.5 =	2 19/32" L
12 =	2 20/32" H
12.5 =	2 22/32" H
13 =	2 24/32"
13.5 =	2 26/32" L
14 =	2 27/32" H
14.5 =	2 29/32" L
15 =	2 30/32" H
15.5 =	3"
16 =	3 1/32" H
L = light (just under) H = heavy (just over)